Set: 4x Turn Signal 12V LED, Sequential, with Turn Signal Mounts and Threaded Sleeves M10

Set: 4x Turn Signal 12V LED, Sequential, with Turn Signal Mounts and Threaded Sleeves

Turn Signal:
- with sequential LED running light function
- 4 pieces, 2 pairs
- 12V
- registration-free thanks to E-mark
- rubber-mounted plastic arm, resistant to light impacts
- Housing: matte Black
- Lens: transparent
- Light color: Orange
- Total length: 115mm
- Length without thread: 95mm
- Depth: 25mm
- Turn signal lens: Length 65mm, Width 15mm
- Thread: M10

Turn Signal Mounts:
- for front (2x) and rear (1x)
- Color: Black
- Outer diameter: Ø 15mm

Accessories:
- 4x Hexagon Nut M10, Black zinc-plated
- 4x Threaded Sleeve M10, 3D-printed, for LED turn signals

Installation Instructions:
- Shorten the turn signal mounts to desired length. (See Tip)
- Protect sawn ends with paint against corrosion.
- Moisten the plastic threaded sleeves with suitable adhesive or high-strength threadlocker and press into the ends of the turn signal mounts. Let dry!
- Optional: Replace nuts on LED turn signal with the supplied black nuts.
- Thread turn signal cable through the threaded sleeves and the turn signal mount, and screw in the turn signal.
- Mount turn signal mounts, align the turn signals, and counter with the nut. (Use common sense, not force!)
- Then wire. (See Note) If in doubt, consult someone with experience in automotive electrical systems.

Note:
Due to the running light function, these turn signals can be operated without a flasher relay. The circuit is integrated in the turn signal, only 12V needs to be applied. (Yellow Cable: Plus + / Black Cable: Minus - )

Tip:
You can also shorten the tubes of the turn signal mounts to give the whole thing a more delicate look. But note the permissible minimum distance between the turn signals! (Distance light emission surface Rear: 180mm, Front: 240mm)

We recommend shortening as follows:
- 10065392 Rear: 40mm, max. 70mm shorter per side
- 10065362 Front: 30mm, max 60mm shorter